穿墙套管的绝缘套管发布时间：2016-06-20 14:18:38 | 来源：乐清米点网络科技有限公司

1.产品概述(General Description)(1) 型号含义

(2) 产品标准：本产品性能符合GB4109-88标准。

(Executive stand：GB4109-88.)

(3) 用途：本系列套管为环氧树脂APG工艺压力凝胶成型结构，它适用于额定电压为12KV、35KV及以下成套设备中，作为绝缘隔离和联接过度用。

(Purpose：Tish series bushing is formed by epoxy resin with APG technics，it isused for insulation and connection transition of completes with rated voltage of 12KV，35KV and below.)

(4) 结构简介：套管耐污及潮湿，无需特别维护，只需定期地清除表面污物。安装时，母排从中穿过。

(Structure：The busing is anti-pollution，moisture resisture and maintenance free，it only needs to clean the dietiness on surface at interval time.The bus is put through during installation.)

2.使用条件(Operation Condition)

(1)户内装置

(Indoor installation)

(2)海拔高度不超过1000M

(Altitude：≤1000m;)

(3)周围气温+40℃~5℃;

(Ambient temperature:+40℃~5℃;)

(4)当空气温度+20℃时，相对湿度布超过85%

(The relative humidity shall not be more than 85%at+20℃ ambient temperature;)

(5)无严重影响触头盒绝缘的气体、蒸汽、灰尘及其它爆炸性和腐蚀介质的场所。

(NO gas ，wapor or dust that may severely affect the insulation of contact box，no explosive or corrosive substance.)

3.产品规格及技术参数(Specification & Technical Parameter)

(1) 额定电压：0、35KV;

(Rate voltage:10、35KV;)

(2)最高电压：12、40.5KV；

(Maximum voltage：12、40.5KV;)

(3)应能承受工频耐压（有效值）42KV、95KV、5min；雷电冲击耐压电压（峰值）：75KV、185KV（注：95KV/185KV为35KV套管试验值

(Power frequency withstand voltage (effective value) ：42KV、95KV、5min；lightning impulse withstand voltage (peakval-ue) ：75KV、185KV (Note：95KV/185KV is test value of 35KV bushing) )

4.套管外形及安装尺寸。(See attached figure for installation dimension of bushing.)

180x110-194套管

欧式穿墙套管

套管100X145X218

套管128-100X100-246

套管140X200-197

套管140X200X230

套管152X152X260

套管210-125X125-233 高压穿墙套管CWB-35/630A

高压穿墙套管CWWL-20/3000A

高压穿墙套管CWC-10/2000A

高压穿墙套管CWWC-20/1000A

高压穿墙套管CB-10/200-630A

高压穿墙套管CWC-10/2000A